![]() ![]() If any of the following conditions occur after the engine has started, eliminate the cause of the incident and perform Idle Air Volume Learning all Use your code reader or scan tool to clear the code. That confirms the reset was done correctly. You should have a malfunction light after this procedure with trouble code P0102 stored. Restart the engine and let it idle for at least 5-secs. To do a Mixture Ratio Self Learning Value Clear procedureĭisconnect the MAF sensor harness connector. Then check idle speed and ignition timing. Release the accelerator pedal within 3 seconds after malfunction light stops blinking and turns ON steady. 20 seconds until the malfunction light stops blinking and turns ON steady. Repeat the following procedure quickly FIVE times within 5 seconds.Īfter the 5 pedal presses, wait 7 seconds and depress the accelerator pedal to the floor again and keep it there for approx. ![]() Turn the key to OFF and wait at least 10-secs.įoot off the pedal, turn key to ON and 3-secs. Then perform the THROTTLE VALVE CLOSED POSITION LEARNING procedure Turn key to OFF and wait at least 10-secs. You cannot do this procedure if you have an accelerator pedal position sensor trouble code stored.ĭO this first Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING procedure: ![]() On CVT models, drive vehicle for at least 10 mins before starting procedure. Steering wheel must be in straight-ahead position) position and vehicle must be stopped If you have daytime running lights (DRL) do this procedure to shut them off:Īpply the parking brake, or set the lighting switch to the 1st position. That means no A/C, headlamp, rear window defogger If you’ve performed a major repair, disconnected the battery, or disconnected a MAF sensor while the engine is running, you may have to perform a Nissan idle relearn procedure (also called an idle air volume relearn procedure).įirst, precondition the vehicle: Idle relearn cannot be done if any of these items are out of spec or are missing for even a second during the procedure.īattery voltage must be more than 12.9 V engine running at idleĮngine coolant temperature must be 158 – 212☏Įlectric load switches OFF. Make and Model > Nissan > 350Z > Nissan idle relearn procedure Nissan idle relearn procedure How to perform a Nissan Idle relearn ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |